Semmoinen ongelma että moottorin vikavalo palaa luin vikakoodin kaasuläpän asentotunnistin viallinen joten vaihdoin sen ja tyhjensin vikakoodin mutta moottorin vikavalo syttyy uudelleen ja taas herjaa asentotunnistinta mistähän mahtaa johtua??

Noiden sopeuttamisesta muistan lukeneeni, pitänee tehdä vaihdon jälkeen. Haulla varmasti löytyy jotain.

Accelerator Pedal Released Position Learning EBS00K3B
DESCRIPTION
"Accelerator Pedal Released Position Learning" is an operation to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time
harness connector of accelerator pedal position sensor or ECM is disconnected.
OPERATION PROCEDURE
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch "ON" and wait at least 2 seconds.
3. Turn ignition switch "OFF" wait at least 10 seconds.
4. Turn ignition switch "ON" and wait at least 2 seconds.
5. Turn ignition switch "OFF" wait at least 10 seconds.
Throttle Valve Closed Position Learning EBS00K3C
DESCRIPTION
"Throttle Valve Closed Position Learning" is an operation to learn the fully closed position of the throttle valve
by monitoring the throttle position sensor output signal. It must be performed each time harness connector of
electric throttle control actuator or ECM is disconnected.
OPERATION PROCEDURE
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch "ON".
3. Turn ignition switch "OFF" wait at least 10 seconds.
Make sure that throttle valve moves during above 10 seconds by confirming the operating sound.

Tyhjäkäynnin sopeutus:
It is better to count the time accurately with a clock.
● It is impossible to switch the diagnostic mode when an accelerator pedal position sensor circuit
has a malfunction.
1. Perform EC-45, "Accelerator Pedal Released Position Learning" .
2. Perform EC-45, "Throttle Valve Closed Position Learning" .
3. Start engine and warm it up to normal operating temperature.
4. Check that all items listed under the topic "PREPARATION" (previously mentioned) are in good order.
5. Turn ignition switch "OFF" and wait at least 10 seconds.
6. Confirm that accelerator pedal is fully released, turn ignition switch "ON" and wait 3 seconds.
7. Repeat the following procedure quickly five times within 5 seconds.
a. Fully depress the accelerator pedal.
b. Fully release the accelerator pedal.
8. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MI stops
blinking and turned ON.
9. Fully release the accelerator pedal within 3 seconds after the MI turned ON.
10. Start engine and let it idle.
11. Wait 20 seconds.

Youtubesta löytyy myös videoita, joista saa ehkä paremman kuvan miten noi tehdään.

kokeilin tehdä ohjeiden mukaan mutta vikavalo syttyy aina uudestaan löysin ohjeita youtubesta kokeilin niitäkin mutta aina vain herjaa asentotunnistinta!

Onkohan siinä TPS:ssä sitten johdot tai liitin paskana? Asensithan sen täysin samaan asentoon kuin aiempi oli?

Tarkka vikakoodikin vois auttaa selvittelyä

No juu selvisi oli vähän tuo asentotunnistin väärässä asennossa nyt toimii ja vikavalo on pysynyt poissa!