Uutiset:

NCF - Nissan Club of Finland

Päävalikko

akun irrotus ----> radion turvakoodin syöttö

Aloittaja maakari, tammikuu 26, 2015, 21:59:35

« edellinen - seuraava »

0 Jäsenet ja 2 Vieraat katselee tätä aihetta.

maakari

Irroitin 2005 almerasta akun ja nyt radio vaatii turvakoodin toimiakseen, mutta näytössä lukee vain "security", eikä anna kirjoittaa koodia mihinkään. Kellään käynyt vastaavaa?

flanders


maakari


Datsuuna

#3

Vaikuttaa, että soitin olisi lukiutunut suojatilaan niin käy yleensä jos sille annetaan koodi väärin monta kertaa kai sinulla oli tiedossa oikea koodi ?
RTV-asentaja ja Datsun/Nissan mies  80-luvulta asti

maakari

Oikea koodi on tiedossa, mutta ongelma on juurikin siinä, etten ole päässyt sitä mihinkään syöttämään.

Asensin soittimeen usb-sovittimen (yatour), jonka yhteydessä siis akun irrotin. Voisiko ongelma siis johtua mahdollisesti väärin kytketyistä johdoista?

Edellinen omistaja osasi myös kertoa irrottaneensa akun joskus, mutta silloin hänellä soitin ei vaatinut turvakoodia toimiakseen.

Datsuuna

LainaaVoisiko ongelma siis johtua mahdollisesti väärin kytketyistä johdoista?

Voisi tai siitä että sovittimen ja soittimen välillä on yhteensopimattomuus ongelma tarkoitat ilmeisesti tätä laitetta https://www.youtube.com/watch?v=8sYpUNmBQs8
RTV-asentaja ja Datsun/Nissan mies  80-luvulta asti

maakari

#6

Kyllä, sama laite. Yhteensopimattomuus ongelmaa ei myyjän mukaan pitäisi olla. Täytynee koittaa kytkeä johdot eritavalla ja katsoa auttaako.

kepugga

Samantapainen ongelma 2005 mallissa, radio ilmoittaa ainoastaan wait 0 min, ei reagoi mihinkään nappiin, koodi löytyy kyllä...

Jylppy

N16 service manuaalista lainattua:

NATS AUDIO LINK

Description
The link with the NATS IMMU implies that the audio unit can basically only be operated if connected to the matching NATS IMMU to which the audio unit was initially fitted on the production line.

Since radio operation is impossible after the link with the NATS is disrupted theft of the audio unit is basically useless since special equipment is required to reset the audio unit.

Initialization process for audio units that are linked to the NATS IMMU
New audio units will be delivered to the factories in the "NEW" state, i.e. ready to be linked with the vehicle's NATS. When the audio unit in "NEW" state is first switched on at the factory, it will start up communication with the vehicle's immobiliser control unit (IMMU) and send a code (the "audio unit Code") to the IMMU. The IMMU will then store this code, which is unique to each audio unit, in its (permanent) memory.

Upon receipt of the code by the IMMU, the NATS will confirm correct receipt of the audio unit code to the audio unit. Hereafter, the audio unit will operate as normal.

During the initialisation process, "NEW" is displayed on the audio unit display. Normally though, communication between audio unit and IMMU takes such a short time (300 ms) that the audio unit seems to switch on directly without showing "NEW" on its display.

Normal operation
Each time the audio unit is switched on afterwards, the audio unit code will be verified between the audio unit and the NATS before the audio unit becomes operational. During the code verification process, "WAIT" is shown on the audio unit display. Again, the communication takes such a short time (300 ms) that the audio unit seems to switch on directly without showing "WAIT" on its display.

When the radio is locked
In case of a audio unit being linked with the vehicle's NATS (immobilizer system), disconnection of the link between the audio unit and the IMMU will cause the audio unit to switch into the lock ("SECURE") mode in which the audio unit is fully inoperative. Hence, repair of the audio unit is basically impossible, unless the audio unit is reset to the "NEW" state for which special decoding equipment is required.

Clarion has provided their authorized service representatives with so called "decoder boxes" which can bring the audio unit back to the "NEW" state, enabling the audio unit to be switched on after which repair can be carried out. Subsequently, when the repaired audio unit is delivered to the final user again, it will be in the "NEW" state as to enable re-linking the audio unit to the vehicle's immobiliser system. As a result of the above, repair of the audio unit can only be done by an authorized Clarion representative.
L18@120Y LB210 -77
120Y KLB210 -75

kepugga

Tuosta pelkästä WAIT ja NEW tekstistä löytyikin tietoa, tuossa hämää tuo aika 0 min.